R&S CMW500 with LabView - Tx Power test case

  • LabVIEW 
1. ./rscmwls/Signaling/Signaling Control and States/ rscmwls Query RRC state.vi 
     => 0 = idle, 1 = connect
2. ./rscmwls/Signaling/Signaling Control and States/ rscmwls Query Packet Switched State.vi
    => 0 = OFF, 1 = ON
  • LabVIEW Signaling Drvier:

Vi Tree check:
1. rscmwls Initialize.vi = Pass
2. rscmwls Close.vi = Pass
3. rscmwls Configure LTE Neighbor Cell List.vi = Pass
4. rscmwls Configure Signal Routing Standard Cell Fading.vi => FAIL
    
-> Instrument Error: -203: -203,"Command protected;ROUT:LTE:SIGN1:SCEN:SCF:INT:FFAD RF1C,RX1,RF1C,TX1"
5. rscmwls Configure Duplex Mode.vi = FDD Pass
TDD-> Instrument Error: -221: -221,"Settings conflict;CONF:LTE:SIGN1:DMOD TDD"

6. rscmwls Configure RF Signal Frequency.vi -> set the Operating Band and Channel
    [only select Uplink]

Result:
rscmwlm Fetch Multi Evaluation Power Monitor.vi
rscmwlm Read Multi Evaluation Power Monitor.vi
rscmwlm Configure Multi Evaluation Measurement Results.vi =>setup the tx
Step:
1. Press [RESET] button.
2. Select [LTE Signaling] \ [ Config...] \ [LTE Signaling]
    in [Cell Setup ] feild : 
Set {Operating Band} {Channel} {cell Bandwidth}


沒有留言:

張貼留言